Suchergebnisse

(Zitat von Lucano99) [Moderation] Hier die Übersetzung (Google Übersetzer): Hallo zusammen. Ich habe versucht, den Holz- und Pelletskessel mit dem kleinen Display auf Version: AWP 200303HC zu aktualisieren und nach dem Upgrade habe ich immer noch einen blauen Bildschirm. Ich habe die ursprüngliche SD-Karte zuvor gesichert, aber aus irgendeinem Grund lässt sich die SD-Karte nicht verbinden. Hat jemand eine andere Firmware-Version, die ich bitte ausprobieren kann? Ich habe den Support des Herstell…

Hi, it is attack Wood and Pellet,.. The fan is fine, as far as I know. Everything is clean. Does anybody has experience with cleaning the combustion chamber? Must it be clean always, when you want to try to use pellets? The temperature is usually about 160-180°C (I will try to raise it to the 200°C), but We were burning many briquettes, that might be the issue with the soots in the chimney. This year I want to burn only dry wood and pellets, so lets see. Also, I will have a serviceman check, aft…

Hi, yep, I saw some of these also, but, this require to have electricity on the roof and mounting to the chimney, but.. the attack part looks better. Can be powered by the same relay as the default fan is, so... very easy to connect. I just want to know, if this can be helpful with the smoke inside the room

Hello everybody, Sorry, I am not good in German language, so I will write my issue in english, if you dont mind. I have attack wood and pellet + 2000l tank. Problem what I have is that the exhaust from the boiler is a bit longer. About 150cm to the chimney and it goes very slightly up. This spring, I cleaned the chimney and saw that the exhaust pipe is almost full of soots. So I vacuumed everything. I have 7,5m high chimney, 200mm diameter, when I am going to add wood, smoke often goes out. I cl…